|
|
Paessler Netflow Tester 1.0 Antivirus Scan Results: - 100% Clean
Paessler Netflow Tester software
have been tested by programsbase.com team against viruses,
spyware, adware and was founded to be 100% clean.
We will recheck this software periodically to assure users that it remain clean.
Note: this award offered by programsbase.com
should be used only by the author/publisher of the Paessler Netflow Tester software.
|
Paessler Netflow Tester 1.0 Antivirus Report
Archive: netflowtester.zip
inflating: netflowtest.exe
Scanning netflowtest.exe
netflowtest.exe: OK
Scanning netflowtester.zip
netflowtester.zip: OK
----------- SCAN SUMMARY -----------
Scanned directories: 1
Scanned files: 2
Infected files: 0
Data scanned: 1.11 MB
Time: 1.385 sec (0 m 1 s)
|
|
|
|
Get The Code for Paessler Netflow Tester 1.0 Antivirus Report:
|
|
|
|
You are welcome to display a text or a graphic link on your website and link-it
to this antivirus report page. Below are the codes: |
Graphic link:
|
Example:
|
|
Text link:
|
Example:
Paessler Netflow Tester Antivirus report from programsbase.com
|
|
|
|
|
Paessler Netflow Tester 1.0 Description:
Paessler Netflow Tester dumps the data of all Netflow packets that a computer receives from a Cisco router. This can be useful when debugging bandwidth monitoring configurations based on Cisco's Netflow protocol. First the Netflow protocol must be enabled and configured on the router. Then the router must be given the IP address of the computer running Netflow tester so that the UDP data packets with Netflow data are sent to that computer.
Just follow these simple instructions:
1) Download Paessler Netflow Tester and then start netflowtest.exe
2) Enter the IP and port number that you have configured as netflow packet target in your Cisco Router. Usually selecting "any IP" should work, in some cases the IP must be explicitly selected.
3) Enable "Start Netflow Collector".
4) You should now see a line in the logfile for each packet the computer receives. Each line shows the time, netflow version, number of flows and the IP of a packet (note: You need netflow version 5 for PRTG Traffic Grapher!)
5) Enable "Show Flow Data" to also show the corresponding flow data.
6) If you do not see any activity then the system does not receive any netflow data (e.g. due to misconfiguration of the router or a firewall blocking the packets, etc.)
|
Download link:  |
|
|
|
